Our Innovative Research and Development Projects
Over the years, InnoTecUK has participated in a number of cross functional, collaborative European and national research projects with notable success. Our research has primarily focused on automation and optimisation of NDT techniques for quality inspection, image processing, signal processing, data management and communication systems.
Some key research projects are listed below.
-
Renewable (Clean Energy)The IntelWindproject and the partners of the consortium seek to largely decrease the number of failures of critical rotating components in wind turbines and minimise the need for corrective maintenance by ... -
MedicalA non-invasive diagnosis system device used for early detection of diabetes mellitus. SkinDetector enables early stage detection and evaluation of microvascular and macrovascular complications of diab... -
Renewable (Clean Energy)The TidalSense Demo condition monitoring system has been developed to detect, locate and classify defects in tidal generator structures. The Demo project will allow the SMEs to demonstrate and validate the... -
Renewable (Clean Energy)The WINTUR DEMO Project aims to demonstrate the structural health monitoring (SHM) system that was developed successfully in the WinTur R4S project, in order to show that such a system is viable for blade ... -
Oil and GasPigWaves Robot provides an innovative solution for internal in-service pipe inspection of pipelines both piggable and currently considered unpiggable by existing internal pigs. PigWaves Robot provides cons... -
Oil and GasThe CleanMine Project aims to provide mine operators with a rapid method of detecting and removing calcium and similar deposits from in service check valves without stopping production, thus extending the ... -
Renewable (Clean Energy)The DashWin Robot is a novel robotic deployment platform. It has primarily been developed for inspection of composite wind turbine blades on-site, through the use of a shearography kit, without dismantling... -
Renewable (Clean Energy)The AUTOWINSPEC project will provide a system to automatically estimate the condition and remaining lifespan of the blades, by eliminating dangerous rope access and reducing downtime whilst increasing prod... -
Oil and GasCommon errors in defect sizing create dangerous situations as size underestimation will result in a pipe prone to failure. Inetec and Enkon, often face this difficult issue when performing inspections for ...
